cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
163
Views
0
Helpful
2
Replies
Highlighted
Beginner

Routing with SVI

Hi,

 

I am trying to route between different VLANs using layer 3 switches in packet tracer, I attached an image of the network, each layer 3 has an SVI for a particular VLAN, for reference MS0 is 192.168.1.1 for vlan 11, MS1 is 192.168.2.1 for vlan 12, also each layer 3 switch has another SVI for vlan 20 (10.20.0.0/24).

 

I am trying to send RIP updates through vlan 20 between the layer 3 switches, so when a device, lets say 192.168.1.2 (vlan11) tries to communicate with 192.168.2.2 (vlan12), sends the packets to the layer 3 switch that acts as his default gateway, and this one will forward the packets to another layer 3 switch, that acts as gateway of the destination network.

 

Can this be accomplished?

 

I attach an image of the network, if more information is needed let me know.

2 REPLIES 2
Highlighted
Rising star

Re: Routing with SVI

Yes, this should work. You are using VLAN 20 as a transit network between 11, 12 etc. All VLAN SVIs including VLAN 20 should be enabled for RIP.

Regards.

Highlighted
Participant

Re: Routing with SVI

Add a kind reminder, don't forget to enable IP routing by the command "ip routing".
CreatePlease to create content
Content for Community-Ad