Solved: Re: Setting HighUtilization Thresholds in CiscoWorks

dionjiles · ‎01-22-2008

I set my HighUtilization threshold in DFM to 75%, but I am still getting alerts at 6% on some of the devices please see screenprint.

Joe Clarke · ‎01-22-2008

Actually, the event is "correct." It is reporting the current utilization is 6.14 x 10^10 %. Clearly this is bogus. We have seen a lot of these problems in DFM. You should open a TAC service request for further troubleshooting. The developers at EMC need to get engaged as these events come from their code.

View solution in original post

Joe Clarke · ‎01-22-2008

Actually, the event is "correct." It is reporting the current utilization is 6.14 x 10^10 %. Clearly this is bogus. We have seen a lot of these problems in DFM. You should open a TAC service request for further troubleshooting. The developers at EMC need to get engaged as these events come from their code.

dionjiles · ‎01-22-2008

Oh thanks for your help. I will open a TAC service request.