cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

85
Views
0
Helpful
0
Replies
Highlighted
Contributor

Setting Interface Config via HTTP Web GUI

Hello All,

I have a need to manually set the Speed and Duplex on interfaces connecting a ISR Router and 3650 Switch in a remote destination. Normally, once you set "no negotiation auto" on an interface you'll loose connectivity between the 2 devices essentially dropping whatever ssh connection I have to that far-end device.

Looking at the new Web GUI in the IOS version 16.6.6 (*both ISR and Switch are running the same 16.6.6 version), it looks like I can manually set Speed and Duplex, and THEN apply the config.

So I'm wondering if I manually set the Switch's interface to Full Duplex/100, then apply the config. Would this be a good way around loosing connectivity once entering "no negotiate auto", and then being unable to set speed and duplex because I've lost connectivity..?

Thanks in Advance,
Matt

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards