cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
941
Views
0
Helpful
3
Replies

Sg200-26p no acces to AP,Ruters via IP

ThinkoSlo
Beginner
Beginner

Sg200 factory settings

Al pc,ap,wap,internet works.

I cant acces the settings to my router,acess points.. via 192.168.1.xxx IP only if i connect to wifi and then settings Ip 192.168.1.xx works.

What is the problem.

Sg200 settings 192.168.254 works over blinking status,no internet modem conected, static 192.168.1.100 network card

3 Replies 3

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend
Al pc,ap,wap,internet works.

bit confused with this statement ? how this works and connected ?

 

After adding new switch and device connected to switch not able to get internet is this correct ?

 

tell us how your network conencted  - by giving small network diagram on Fagsheet.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

ThinkoSlo
Beginner
Beginner

my 2 routers are connected to sg200-26p switch. Trafic is normal,wifi normal,internet going.
Buth i cant acces routers web manegment on IP 192.168.1.1/2. time out error

 

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend
Buth i cant acces routers web manegment on IP 192.168.1.1/2. time out error

where is this router connected , from what IP address#(source) you trying to connect ? - where is this source  device connected in the switch ?

are you able to ping ?

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: