02-25-2021 06:49 AM
Hello,
I have enabled SNMP on the 2960 switch and would like only one device (PC) to be able to monitor, block everything and release only one ip;
How should I proceed?
02-25-2021 06:56 AM
try below config :
snmp-server community public RO 5 < you enabling SNMP with community with ACL
access-list 5 permit x.x.x.x <-- X.x.x.x is IP address to allow polling SNMP Server
02-25-2021 07:00 AM
Will this block all other ips?
02-25-2021 07:11 AM - edited 02-25-2021 07:13 AM
yes correct - test and advise.
you can also do as below :
snmp-server host x.x.x.x public ( x.x.x.x is IP address to allow and Public is community)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: