cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2033
Views
5
Helpful
1
Replies

SNMP OID Issue for 6509 Modules

We have a single 6509 and a pair of 6509's in a VSS config. We want to be able to monitor all the device modules using snmp. On the single 6509 we can grab the moduleModel (17) and moduleStatus (10) using OIDs .1.3.6.1.4.1.9.5.1.3.1.1.17 and 1.3.6.1.4.1.9.5.1.3.1.1.10 respectively. Using the same OIDs we get nothing for the VSS 6509s.I've even tried walking the entire .1.3.6.1.4.1.9.5.1.3.1.1.X range and still get nothing.

All 3x6509 are running 12.2(33)SXI2a and VS-S720-10G sup modules. On the VSS pair we can definitely get SNMP information as we are monitoring link bandwidth, cpu, mem etc. Is there some bug around this or because it's in a VSS pair do they use a different OID to get the module information?

 

SNMP Object navigator for reference:

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.5.1.3.1.1.10#oidContent

 

Thanks

1 Accepted Solution

Accepted Solutions

Vinod Arya
Cisco Employee
Cisco Employee

VSS switch should be using the cefcModuleOperStatus object from the CISCO-ENTITY-FRU-CONTROL-MIB.

-Thanks

Vinod

**Encourage Contributors. RATE Them.**

-Thanks Vinod **Rating Encourages contributors, and its really free. **

View solution in original post

1 Reply 1

Vinod Arya
Cisco Employee
Cisco Employee

VSS switch should be using the cefcModuleOperStatus object from the CISCO-ENTITY-FRU-CONTROL-MIB.

-Thanks

Vinod

**Encourage Contributors. RATE Them.**

-Thanks Vinod **Rating Encourages contributors, and its really free. **
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: