I have about 20 switches in my enviornment. for some reason, I can't get interface utilization on Cisco netManager. At one time, I had this running, but someone it doesn't seem to be. Maybe there is something wrong with my config. So, I will use the most important switch, a 3750 as the example.
This is runnning version 12.2 (55) SE4 of the IOS.
This is a common configuration for the switchport:
description UPLINK PORT
switchport trunk encapsulation dot1q
switchport mode trunk
mls qos trust dscp
This is the snmp portion of the config:
snmp-server community bpsnmp RO
snmp-server location springfeild MDF 3750
snmp-server host 192.168.110.34 bpsnmp
This snmp server is Cisco netManager. I have it configured with the right credentials and it's showing that device is up via snmp & icmp.
But for some reason it doesn't want to collect or maintain any interface utilization information. For that matter, it netManager isn't really retaining any data. So, maybe the problem is more on the netManager end. But, I wanted to verify that there isn't anything in particular that I should be putting on the switch.
Hello I am getting this following error and get ACTV, XPS and S-PWR LEDs amber then suddenly all LEDs are off: Booting...(use DDR clock 667 MHz)*** Coprocessor Unusable Exception ***PC = 0x00000000 00000000SP = 0x00000000 00000000Cause Reg...
Once Cisco DNA Center has provisioned the SD-Access devices to sites, the SD-Access fabric can be created. In the Cisco DNA Center UI, navigate to Provision > Fabric. This is where you create and manage your fabric domains and transits.]
Provision Discovered Devices
On the Cisco DNA Center UI, navigate to Provision page
Select the following devices and provision all the devices to Floor-1. During the provision workflow, Cisco DNA Center can only provision devices of similar family. We wi...