cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
541
Views
0
Helpful
5
Replies
Highlighted
Beginner

Syslog to SNMP

There are CA Unicenter and Cisco LMS. I want to receive events reports from LMS on Unicenter. Unicenter doesn`t support syslog, it supports snmp.

Can I convert some syslog messages to snmp traps and send it to Unicenter?

5 REPLIES 5
Highlighted
Cisco Employee

Re: Syslog to SNMP

LMS won't forward syslog messages to another NMS server, it can only forward syslogs froma remote collector to a central LMS server.

It cannot convert these syslog messages to snmp traps for forwarding.

DFM can forward snmp traps, but these do not come in as syslog messages.

Highlighted
Beginner

Re: Syslog to SNMP

thanks for you answer!

Do you know how LMS integrated into CA Unicenter at all?

Highlighted
Cisco Employee

Re: Syslog to SNMP

There is an integration utility for CA Unicenter with LMS. It comes as part of the Common Services install or you can download it on CCO under CiscoView software -- Integration Utility

Highlighted
Beginner

Re: Syslog to SNMP

Integration Utility 1.6 supports the following

Here

http://cisco.com/en/US/products/sw/cscowork/ps3996/products_user_guide_chapter09186a008036e125.html

is an infirmation I read:

Network Management Systems (NMS) for integrating CiscoWorks applications with them.

?HP Network Node Manager 6.4.

?HP Network Node Manager 7.0.

?HP Network Node Manager 7.0.1.

?NetView 7.1.

Does it mean that CA Unicenter isn`t supported?

Highlighted
Beginner

Re: Syslog to SNMP

You can convert DFM events into syslog events and forward them to an external syslog server.

This is done under DFM Notification Services by creating a new Notification Group with the devices you want to monitor. Then go under the Syslog Notification tab and add a subscription name, the Notification Group you just created, select the syslog facility(you may need to check the facility CA will accept), and a location name. Select next, and the next screen will allow you to specify the syslog server IP address and the syslog port(CA in your case?). I have successfully been able to send DFM data via syslog using this method. Syslog format may vary depending on the facility specified in the creation steps but can be edited.

Hope this helps you out,

Regards

Content for Community-Ad
This widget could not be displayed.