I have an RBE network environment with a 7204 VXR router as a broadband aggregator device.
The 7204 is connected to ATM network of the incumbent operator of my country.
My subscriber uses RFC1483 devices and receives IPv4/IPv6 addresses, using DHCP option 82, from an external DHCP server connected to 7204VXR.
The 7204 has a different subinterface ATM for each PVC connection. As usual the VCs shared the same bandwith of a Virtual Path (VP).
At the moment I need to control the bandwith used by each subscriber (VC) in order to avoid possible greedy behaviours.
I have tried to use the rate-limit command in the subinterface with poor results.
I'm looking for a dynamic way to reduce the bandwith of a greedy customer in steps-like way.
The subscribers share a VP (bandwith of 10 Mbps simmetric). Each subscriber connects to the access network in ADSL tecnology (D: 7Mbps U: 512kbps with an MCR of 32kbps) and his respective VC are routed by ATM switch to my 7204 aggregator router.
At the beginning a customer can use all of the 7Mbps, but if he continues to use all the bandwith, the 7204 starts a policy to decrease the customer's speed. So the bandwith decreases to 6Mbps, then if the greedy behaviour continues the bandwith should be decreased again to 4Mbps and so on.. until the bandwith reaches the MCR (Minum Cell Rate) value of 32kbps.
If the customer stops his greedy behaviour the bandwith will increase to his original value.
Which tecnology, device, theory should I buy/configure/implement in order to achieve this result?
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 184.108.40.206 as the RP for these groups:220.127.116.11/3218.104.22.168/3222.214.171.124/24126.96.36.199/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...
Meet the Authors Event - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT ...