10-27-2014 06:30 AM
Hi Guys,
I need to troubleshoot an package loss issue and for that I would like to use "monitor capture" but it just do not start, see bellow.
ASR1001#sh monitor capture cap_out
Status Information for Capture cap_out
Target Type:
Interface: GigabitEthernet0/0/1, Direction: both
Status : Inactive
Filter Details:
Access-list: acl-out
Buffer Details:
Buffer Type: CIRCULAR
Buffer Size (in MB): 10
Limit Details:
Number of Packets to capture: 0 (no limit)
Packet Capture duration: 60
Packet Size to capture: 0 (no limit)
Maximum number of packets to capture per second: 1000
Packet sampling rate: 0 (no sampling)
ASR1001#monitor capture cap_out start
Unable to activate Capture.
Did anyone face that?
Regards
12-03-2014 02:24 AM
I had this problem too.
When I cleared the "log" extension at the ends of the access-list lines then the problem have been settled.
01-29-2016 08:40 AM
Thanks, worked for me.
11-13-2018 12:43 AM
I had the same issue.
Mine was caused by trying to capture an interface belonging to a port-channel.
Capturing on the port-channel instead of the physical interface resolved this.
11-13-2018 12:44 AM
I had the same issue.
Mine was caused by trying to capture an interface belonging to a port-channel (on a 4500X).
Capturing on the port-channel instead of the physical interface resolved this.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: