cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1045
Views
0
Helpful
4
Replies
Highlighted
Beginner

Very big ICserver.log

Hello,

I have LMS 3.2.1 which ICserver.log is growing rapidly - in 5 days 32GB. An it's full only with "I have got connection".

It was clean install of LMS 3.2, restore of 3.1 backup, and then LMS 3.2 SP1. I'm think that before SP1 ICserver.log was OK but I'm not sure...

Regards,

Mladen

4 REPLIES 4
Highlighted
Cisco Employee

Hi ,

You can truncate this log file as below :

On the command Prompt :

NMSROOT\CSCOpx\log>logrot_trunc ICserver.log

Truncating this log file will create any issues.. It might possible that somehow the Debugging  has been enabled for Inventory which is causing this..

To reset the Debugging level :

Go to  RME --> Administration --> System Preferences --> Loglevel Settings, click "Default" to reset the logging levels.

Thanks--

Afroj

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
Highlighted

Hello,

rlogrot_trunc don't work, ot I doing something wrong:

Here is ICServer.log before executing command

and command (it was executed only once)

I't looks OK for some time

But after some time size jumps back to previous value...

I was reset debbuging level to default, as you can see there wasn't problem...

Regards,

Mladen

Highlighted

Hi,

One of my customer has the same issue: ICServer.log is growing very fast.

We try to purge with logrot trunc command, it works but few minutes later file is huge.

Customer is LMS 3.2 and we have the same message: I have got connection

Did you find a solution to resolve this critical issue ?

Many thanks,

Elisabeth

Highlighted

Hello,

Unfortunately no...

Mladen

Content for Community-Ad