We were using WCS for managing and reporting for our wifi access-points. The reporting was done using email configured in the WCS SMTP settings. The SMTP settings used did not have a password then and worked properly. Now as the mail servers have been upgraded and authentication has become compulsory the current login settings include username and password. When I enter the username and password in the SMTP settings in WCS and click on Test , it sends the mail successfully. But when I click save and then test, the mail sending fails. It is noted that the password is not getting saved or is getting saved incorrectly. Tried this procedure for both primary and secondary mail servers and same result. This is critical for us as now the reports are not being sent automatically as it should.
Join us live on Tuesday, March 9 at 10 am PT (and on demand after) as we take a closer look at the WAN architecture innovations that Cisco has to offer.
We'll take your questions live during the broadcast (and after), so post them below in the comments.
Hello everybody,I am newbies with setting cisco switch.I downloaded Catalyst 2960-X Switch Getting Started Guide but I can't access to Device Manager - Express Setup according to guide.If you follow the instructions and try to keep all LEDs (exc...
To participate in this event, please use the button to ask your questions
Ask questions from Monday, March 8 to Friday, March 19, 2021
All the knowledge of these four experts at your disposal!
Cisco Software-Defined Wide Area Network (SD-WAN) provid...
Community Live- ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
(Live event - Tuesday, 23 March, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event will have place on Tuesday 23rd, March 2021 at 10:00 hrs PDT&...