Hello Community, someone recently push the Mode button for too long and the Switch Stack restarted in Express Setup. Is this the normal behavior on the Mode Button? Where were debating that the Whole Stack was not supposed to erase or not if the button was press for to long. One of my colleagues told me that the next Stack member should maintain the configuration as the master and only the one that was pressed was the only that will take enter the Express Setup config. I can't find any documentation about the specific case For my understanding I tough that they should all take a dump if you hold the Mode button on the Master Stack Switch. Will the factory reset will be performed on all 3 Switches on the Stack or just the Switch that was pressed?
Yes, this is a normal behaviour. Disable the mode button by using the command "no setup express".
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
