03-06-2008 04:32 AM - edited 03-11-2019 05:13 AM
Hi all,
We create new VLANs & will assign these VLANs to the Firewall Services Module
By using the below command:-
(Config)# Firewall vlan-group firewall_group vlan_range
My question is there any need to restart the FWSM after adding new vlan into vlan group??
Regards
03-06-2008 05:18 AM
Hi
No you don't have to reboot anything. Just make sure if you are running a pair in separate chassis that you update both firewall vlan-group entries on both 6500's because if they become out of sync then failover will not work.
HTH
Jon
03-06-2008 05:41 AM
Hi Jon ,
Many thanks for your prompt response
Regards
Matalla
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: