Access problem from Inside to DMZ and outside to DMZ
So long time lurker, first time poster. These FTD firewalls are making me feel like a greenhorn again. I've slogged through the initial configuration, have interfaces and etherchannels finally working... but cannot for the life of me configure access from our inside networks to our DMZ. I configured NATs in the vein of our configuration on the older ASA5525s without success.
The Access-rules should be similar to what you have on the ASA version 8.3+. You do not need a NAT to go from inside to DMZ. You can however add a NAT exempt to exempt inside to DMZ traffic from any translation.
DMZ to outside would require an Auto NAT rule. Also, an ACL would be needed from Outside to DMZ to allow internet users to access your public DMZ servers.
It would be good if you can show us an example of what you have configured and what is not working.
We have the Endpoint purge to delete any thing over 365 days, but this wasn't working as standard since in was installedSo disabled and enabled again and this seem to fix it, as had just under 200k endpoints captured. But it removed all clients that ...
When we unregister FTD from FMC and re-register, all the static routes are lost on it. Sometimes device has database corruption, if re-image is the only solution then upon re-image, FTD comes up fresh and we need to configure everything from scra...
Hi,I have a very simple question; we have two ASA 5585-X working in Active/Standby Mode with multiuser Contexts.Normally Primary Unit is active for failover group 1 and 2; Secondary Unit is standby !At the moment our Secondary Unit is completely disconnec...
Meet the Authors Event - CCIE Security and Practical Applications in Today’s Network: Zero Trust
(Live event – Thursday, 29th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 6:00 p.m. Paris)
This event will have place on Thursday 29th, October 2020 at 1...
My company uses Microsoft Azure AD, and I sign into all my applications using that account. Can I use that account when I sign in?
Yes - all applications that support SecureX sign-on allow direct login with your Microsoft Azure AD accou...