Hi I have been using a few days the firewall ASA5505 they've completely put new, the ASA Version 8.4 (2) have been playing and the ASDM version 6.4 (9). I have the Basic Config loaded with the command "conf t" and "Facorty default-config."
Now I want to connect to this firewall, but this is not because he always says he unable to connect to the firewall. The IP settings I have the following: IP address 192.168.1.6 Subnet: 255.255.255.0 Gateway: 192.168.1.1. How can I connect to or what I'm doing wrong?
Executing command: interface Ethernet 0/0
Executing command: switchport access vlan 2
Executing command: no shutdown
Executing command: exit
Executing command: interface Ethernet 0/1
Executing command: switchport access vlan 1
Executing command: no shutdown
Executing command: exit
Executing command: interface Ethernet 0/2
Executing command: switchport access vlan 1
Executing command: no shutdown
Executing command: exit
Executing command: interface Ethernet 0/3
Executing command: switchport access vlan 1
Executing command: no shutdown
Executing command: exit
Executing command: interface Ethernet 0/4
Executing command: switchport access vlan 1
Executing command: no shutdown
Executing command: exit
Executing command: interface Ethernet 0/5
Executing command: switchport access vlan 1
Executing command: no shutdown
Executing command: exit
Executing command: interface Ethernet 0/6
Executing command: switchport access vlan 1
Executing command: no shutdown
Executing command: exit
Executing command: interface Ethernet 0/7
Executing command: switchport access vlan 1
Executing command: no shutdown
Executing command: exit
Executing command: interface vlan2
Executing command: nameif outside
INFO: Security level for "outside" set to 0 by default.
Executing command: no shutdown
Executing command: ip address dhcp setroute
Executing command: exit
Executing command: interface vlan1
Executing command: nameif inside
INFO: Security level for "inside" set to 100 by default.
Executing command: ip address 192.168.1.1 255.255.255.0
Executing command: security-level 100
Executing command: allow-ssc-mgmt
ERROR: SSC card is not available
Executing command: no shutdown
Executing command: exit
Executing command: object network obj_any
Executing command: subnet 0.0.0.0 0.0.0.0
Executing command: nat (inside,outside) dynamic interface
Executing command: exit
Executing command: http server enable
Executing command: http 192.168.1.0 255.255.255.0 inside
Executing command: dhcpd address 192.168.1.5-192.168.1.36 inside
Executing command: dhcpd auto_config outside
Executing command: dhcpd enable inside
Executing command: logging asdm informational
Factory-default configuration is completed
ciscoasa(config)# wr
Building configuration...
Cryptochecksum: ee2b2e47 c2886bf3 b45f3afb bccbfb1e
