I'm trying to understand why the keyword "default" in the ACL is needed.
Ext Access List configuration commands:
<1-2147483647> Sequence Number
default Set a command to its defaults
deny Specify packets to reject
permit Specify packets to forward
R3(config-ext-nacl)#default permit icmp any any
R3(config-ext-nacl)#do sh access-l
Extended IP access list log-test-1
10 permit ospf any any (1201 matches)
ip access-list extended log-test-1
permit ospf any any
In the output of the command "show access-list" and in the output of the config (show running-config) it is not displayed. Please, tell me why it is needed and how to apply it.
Thank you very much for your reply, but unfortunately, it has not helped much. Tried to repeat what you said - did not work. Will not it make it difficult for you to show a listing or pseudo-listing of step-by-step usage so i can see how to apply it?
It gives me great pleasure to announce that FMT 2.1 supports the migration of the Palo Alto firewall to FTD.
Tool flawlessly migrates the following component of PA configuration
Network Object and Groups
Hi All, I was building VPN firewall using two Cisco ASA 5516 boxes. I want to use single ISP shared between both ASA. I've chosen two Public IPs and configured on ASA units. I've picked another IP for VPN Load-Balancing. Does this support for S2...
Hi Everyone, hoping that someone can help me out. I just migrated my AnyConnect VPN configuration from a 5505 to 5506x FW. The configuration looks fine after checking but when client try connected to the below group-url they say that they get a...
This article is intended to be a simple example of configuring AnyConnect relevant syslog messages to be sent from the ASA to a Syslog server. The syslog server in this example is Spunk but almost any syslog server should be do the job. The ...
NGFW Spring 2020 Releases
It’s official! FTD 6.6, ASA 9.14.1, and FXOS 2.8 have been released. We want to thank the hundreds of team members for the tens of thousands of man-hours dedicated to driving this critical release over the finish line. 120...