06-27-2013 02:43 PM - edited 03-11-2019 07:04 PM
Hi,
How can I run ACTIVE/ACTIVE firewall in GNS3??
I tried in google and FB groups but didnt get answer that works.
So,I did finally multimode option in ASA but then I couldnt config IP addresses on interfaces!!!!
Thanks in advance.
Bye,
Solved! Go to Solution.
06-28-2013 08:59 PM
Hello Anand,
It should work, I have done it
Make sure you have the licenses to run it,
Regards
Remember to rate all of the helpful posts.
For this community that's as important as a thanks.
06-29-2013 11:55 PM
Hello Anand,
Yeah you already did it (thanks mate)
Glad to know everything is up and running
Remember to rate all of the helpful posts.
For this community that's as important as a thanks.
06-28-2013 08:59 PM
Hello Anand,
It should work, I have done it
Make sure you have the licenses to run it,
Regards
Remember to rate all of the helpful posts.
For this community that's as important as a thanks.
06-29-2013 02:47 PM
Thanks,
I did it.It was context problem, I didnt config in context mode in ASA and tried in system mode that is why I couldnt config addresses. Now all done.
Bye,
06-29-2013 02:49 PM
How to give rating u have one rating right!!!
06-29-2013 11:55 PM
Hello Anand,
Yeah you already did it (thanks mate)
Glad to know everything is up and running
Remember to rate all of the helpful posts.
For this community that's as important as a thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: