07-10-2009 02:48 AM - edited 03-10-2019 04:41 AM
Hi,
we have this module on an ASA 5540, while the inspection load is reaching a max of 35% , the cpu is reaching 100% sometimes.
1- how do i check the current bandwidth in Mbs being inspected ?
2- how do i check if there is drops when cpu is reaching 100%
3-if cpu hangs at 100% will fail-open work or will the module start dropping legitimate packets
4- should i upgrade my card to AIP-SSM 40 allthough inspection load is still 35% ?
Thank you
07-16-2009 01:06 PM
Check if you are hitting the bug CSCsw25900.
07-20-2009 05:08 AM
thank you but its not , can anyone answer these questions plz.
07-20-2009 07:23 AM
To check if your sensor is dropping packets, get on the CLI and run
show interface - This will show you an averaged packet loss across all interfaces since last reset and on a per-interface basis.
show event stat past 01:00 inc missed - This will show you any peaks in your missed pckets over the last hour.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: