Allow LAN access from Anyconnect remote client

[Steven Williams]

Following this article I cannot get local lan access to work.

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/70847-local-lan-pix-asa.html

created an acl:

access-list Local_Lan_Access standard permit host 0.0.0.0

Also NAT Exempt:

nat (outside,outside) source static VPN_NAT VPN_NAT destination static VPN_NAT VPN_NAT description NAT EXEMPT

still nothing. Thoughts?

[Steven Williams]

Ugh. Its a routing issue. These ASA's are setup parallel to the current ASA and core 4500s have the default route heading that way, so the return traffic from internal hosts are not getting back to anyconnect clients. I hate testing in migration network setups.