01-26-2015 06:54 AM - edited 03-11-2019 10:23 PM
Hi all,
I have a Pix 515e version 6.1
I have already enabled the pptp on the ACLs.
Thanks.
01-27-2015 12:20 AM
Hi,
If you have a device in the LAN to which you connect then I think you will need to configure Static NAT for that device to give it a public IP address. There is also a "inspect pptp" configuration.
The software on your firewall is so old that I am not sure what the configuration format is though. I think in the older softwares the above "inspect" command was actually "fixup pptp"
I would suggest looking at replacing your current firewall. The current software level is very very old.
- Jouni
01-27-2015 05:18 AM
Hello Jouni,
I have the static route configured
If
Thanks.
01-28-2015 11:06 AM
Hi all,
Know
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide