- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-10-2012 02:01 PM - edited 03-11-2019 04:40 PM
Hi,
I just installed an AnyConnect Mobile license on an ASA 5510 but haven't had time to do much else. Does the ASA require any further configuration to support mobile clients, or will the existing AnyConnect setup suffice?
Thanks.
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-11-2012 01:54 AM
It's enough to install the license. You don't need any other config to let your mobile users in.
Sent from Cisco Technical Support iPad App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-11-2012 01:54 AM
It's enough to install the license. You don't need any other config to let your mobile users in.
Sent from Cisco Technical Support iPad App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-11-2012 02:01 PM
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-03-2013 09:42 PM
Additional tasks can be done such as modify the client profile for the tunnel group if you would like to control "Connect on Demand". This feature allows the app to establish a vpn tunnel when a specific URL suffix is matched. This requires cert authentication
Sent from Cisco Technical Support iPhone App
