Anyconnect VPN on ASA 8.3+ ?

[ahmad82pkn]

            Hi. i wanted to configure Anyconnect on my ASA running version 8.6, but i couldnt find any good documentation.

all i found is pre 8.3 documentation. and from that SVC commands are not available any more.

Below is a smaple configuration from a website. but i dont have SVC command on my ASA . what is alternative command for this?

is it depreciated?  can any one give me good CLI tutorial for configuring anyconnect VPN on 8.3 + ASA? Thanx in advance

Enable WebVPN

ASA(config)#

webvpn

enable outside

ASA(config-webvpn)#

svc image disk0:/ <anyconnect image file name>

ASA(config-webvpn)#

svc enable

[Jouni Forss]

Hi,

I think the "svc" commands changed to "anyconnect" in the 8.4(1) software so you might have to try using "anyconnect" instead of "svc"

Your best bet is to go through the Configuration Guides and Command Reference

Configuration Guide (AnyConnect)

http://www.cisco.com/en/US/docs/security/asa/asa84/configuration/guide/vpn_anyconnect.html#wp1074591

Command References

http://www.cisco.com/en/US/docs/security/asa/asa84/command/reference/cmdref.html

Hope this helps

Please do remember to mark the reply as the correct answer if it answered your question.

- Jouni