cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

227
Views
0
Helpful
0
Replies
Highlighted

Applying policy based routing on ASA BVI interfaces.

Would like to apply policy based routing [policy-route route-map <route-map name>] on a BVI interface or physical interface in the bridge group for my INSIDE network, so I can be able to route certain traffic generated from the INSIDE network out on a specific OUTSIDE interface between the 2 ISP interfaces connected to the ASA. Is the a way to apply policy based routing on the BVI interface or one of the physical interfaces that are part of the bridge group?

# CONFIGURATIONS

The step below was completed successfully.

route-map <route-map name> permit 2 

  match ip address <access-list name>

  set ip next-hop <next-hop ip address>

 

Where I am have difficulty is when having to apply the route map created using the commands above to the BVI or an interface that is part of the bridge group:

# On BVI

<hostname>(config)# int BVI1
<hostname>(config-if)# policy?

configure mode commands/options:
  policy-list   policy-map
<hostname>(config-if)# policy

# On interface that is part of the bridge group

<hostname>(config)# int g0/4
<hostname>(config-if)# policy?

configure mode commands/options:
  policy-list   policy-map
<hostname>(config-if)# policy


The command policy-route does not appear on the list of available commands, but on any other interface that is not part of the bridge group the command is present.

<hostname>(config-if)# int g0/1

<hostname> (config-if)# policy?

interface mode commands/options:
  policy-route

configure mode commands/options:
  policy-list   policy-map

d routing on the BVI interface or one of the physical interfaces that are part of the bridge group?