ASA 5505 ROMMON after erase flash

[siriussystems]

I was trying to erase some bad test configs on my 5505 with a write erase, but all VLAN and Ethernet configs remained.  I hastily decided to do an erase flash.  No I'm stuck at a ROMMON prompt with no image found to boot I'm hoping I don't have to TFTP a factory image.  How do I find the images on disk0 and copy them?

[siriussystems]

THANK YOU!  That finally worked.  Took a little longer than necessary.  You've been very helpful.  We might've avoided some confusion if some of the communication was more descript.  It would've helped to have explanation as to the reasons for each command.  For example, why you instructed me to config-register 0x41 instead of 0x01.  I could've tried that one if there was another option.

Also, do I need to save-config on every reload if changes were made? Is there another place to save config?

[Julio Carvajal]

Hello Armand,

Correct, working from here without seeing what is actually happening on the other side is kind of difficult

Good to know it is working now

Now, if you need to reboot and you have made changes to the configuration just do a write mem. As we are on the right configuration-register you will boot with the startup-config. So you are good to go!

Regards,

Remembe to rate all of the helpful posts