02-17-2016 06:35 AM - edited 03-12-2019 12:19 AM
I need to set up a DMZ interface for my ASA 5506 (IOS ver 9.5.2) that's set up as an Easy VPN client. When I try to modify the third interface I get this: "ERROR: This configuration cannot be modified with Cisco Easy VPN Remote enabled."
Googling around I found this thread which says such a thing should be possible but doesn't mention the above error message: https://supportforums.cisc
Googling around for that error message I can only find the below two posts that don't seem to have anything to do with my issue:
https://supportforums.cisc
https://supportforums.cisc
I have the sneaking suspicion I can't have Easy VPN (client) and DMZ set up on the same device but I hope I'm wrong. Any help is appreciated.
Solved! Go to Solution.
02-17-2016 02:22 PM
Change from using EasyVPN remote to a standard site to site VPN.
EasyVPN remote is designed for connecting up small client connections, and there is no concept of a DMZ in this case.
02-17-2016 02:22 PM
Change from using EasyVPN remote to a standard site to site VPN.
EasyVPN remote is designed for connecting up small client connections, and there is no concept of a DMZ in this case.
02-22-2016 01:15 PM
I think you're right here. I also noticed Easy VPN was not supported on 5506 until recently last year.
Anyone knows if Cisco plans to drop this tech after all?
02-22-2016 11:41 PM
I don't believe there is any intention to drop EasyVPN support.
02-23-2016 01:15 PM
Gentlemen, I found an alternate solution as apparently there's no such thing as a DMZ when you have an Easy VPN firewall.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide