cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
882
Views
0
Helpful
3
Replies

ASA 5510 vlan

Hi!

I need to be able to create vlans in my ASA 5510.

I can'T find anywhere to do this.

I've tried the "routers command" I know, like vlan databse and it does'nt work

Is there a way to "enable" vlan on a ASA 5510 ?

Thanks

Compiled on Fri 20-May-11 16:00 by builders

System image file is "disk0:/asa825-k8.bin"

Config file at boot was "startup-config"

3 Replies 3

cadet alain
VIP Alumni
VIP Alumni

Hi,

just do like this:

int f0/0

interface f0/0.2

vlan 2

ip address x.x.x.x y.y.y.y

nameif  xxx

security-level x

no sh

interface f0/0.3

vlan 3

ip address x.x.x.x y.y.y.y

nameif  xxx

security-level x

no sh

Regards.

Alain.

Don't forget to rate helpful posts.

Thanks but I dont understand why the 5505 uses switchport commands...

Sent from Cisco Technical Support iPhone App

Hello Jean,

The way Cadet Alain said it is the way it should be configured on an ASA 5510.

So on ASA 5510 and higher plataforms each vlan that is carried over the trunk link terminates on a unique subinterface of a physical interface but on the ASA 5505 each vlan is defined by a unique vlan interface and can connect to physical interfaces and be carried over a vlan trunk link.

Hope this helps and if this answers all of your questions please mark the question as answered.

Regards,

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Review Cisco Networking for a $25 gift card