ASA 5525 Config

[robertokippins]

Hello, I am trying to configure an ASA5525 and it's not allowing me to assign an IP address to the interfaces.

These are al the options I get in interface config mode.

[balaji.bandi]

Not sure what interface you try to configure here is example config and order of operation in ASA :

Interface Ethernet0/0
nameif outside
security-level 0

ip address x.x.x.x 255.255.x.x

[robertokippins]

Yes, I'm aware of the configurations but I'm on this G0/0 interface and the configuration options are not there as shown in the screenshot.

[Richard Burts]

Those options seem very odd to be in normal interface config mode. Can you give us the screenshot of going into global config and then into interface config, and then the available options?

[Marvin Rhoads]

A couple of things could cause this. The most common things to check would be:

1. Is your account a level 15 (full admin) user?

2. Is the interface already part of a portchannel interface?

[robertokippins]

HERE IS THE CURRENT RUNNING CONFIG INT HE FIREWALL

ciscoasa# SH RUN
: Saved
:
: Serial Number: FCH200871NC
: Hardware: ASA5525, 8192 MB RAM, CPU Lynnfield 2394 MHz, 1 CPU (4 cores)
:
ASA Version 9.2(2)4 <system>
!
hostname ciscoasa
enable password 8Ry2YjIyt7RRXU24 encrypted
no mac-address auto
!
interface GigabitEthernet0/0
!
interface GigabitEthernet0/1
shutdown
!
interface GigabitEthernet0/2
shutdown
!
interface GigabitEthernet0/3
shutdown
!
interface GigabitEthernet0/4
shutdown
!
interface GigabitEthernet0/5
shutdown
!
interface GigabitEthernet0/6
shutdown
!
interface GigabitEthernet0/7
shutdown
!
interface Management0/0
shutdown
!
class default
limit-resource All 0
limit-resource Mac-addresses 65535
limit-resource ASDM 5
limit-resource SSH 5
limit-resource Telnet 5
!

ftp mode passive
pager lines 24
no failover
no asdm history enable
arp timeout 14400
no arp permit-nonconnected
ssh stricthostkeycheck
console timeout 0
username rkippins password KpTB8vmX/8lQra3Q encrypted privilege 15
prompt hostname context
call-home
profile CiscoTAC-1
no active
destination address http https://tools.cisco.com/its/service/oddce/services/DDCEService
destination address email callhome@cisco.com
destination transport-method http
subscribe-to-alert-group diagnostic
subscribe-to-alert-group environment
subscribe-to-alert-group inventory periodic monthly 17
subscribe-to-alert-group configuration periodic monthly 17
subscribe-to-alert-group telemetry periodic daily
Cryptochecksum:09221d4fd62243052e12d518ca3aaf9c
: end
ciscoasa#