Hello guys, can somebody help me?
I can't access the IPS software module in the ASDM. When I try acess I got the error message:
Error connecting to sensor. Error Loading Sensor
Output from ASA:
ASA# sh module ips details
Getting details from the Service Module, please wait...
Card Type: ASA 5525-X IPS Security Services Processor
Model: ASA5525-IPS
Hardware version: N/A
Firmware version: N/A
Software version: 7.1(4)E4
App. name: IPS
App. Status: Up
App. Status Desc: Normal Operation
App. version: 7.1(4)E4
Data Plane Status: Up
Status: Up
License: IPS Module Enabled perpetual
Mgmt IP addr: 11.0.0.2
Mgmt Network mask: 255.255.255.0
Mgmt Gateway: 11.0.0.1
Mgmt Access List: 0.0.0.0/0
Mgmt web ports: 443
Mgmt TLS enabled: true
I can access the IPS from ASA, but I can't ping the IP address from ASA, access from my LAN or access from ASDM from AnyConnect VPN session:
ASA# sh module ips details
Getting details from the Service Module, please wait...
Card Type: ASA 5525-X IPS Security Services Processor
Model: ASA5525-IPS
Hardware version: N/A
Firmware version: N/A
Software version: 7.1(4)E4
App. name: IPS
App. Status: Up
App. Status Desc: Normal Operation
App. version: 7.1(4)E4
Data Plane Status: Up
Status: Up
License: IPS Module Enabled perpetual
Mgmt IP addr: 11.0.0.2
Mgmt Network mask: 255.255.255.0
Mgmt Gateway: 11.0.0.1
Mgmt Access List: 0.0.0.0/0
Mgmt web ports: 443
Mgmt TLS enabled: true
ASA# session ips console
Opening console session with module ips.
Connected to module ips. Escape character sequence is 'CTRL-^X'.
ASA# ping 11.0.0.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 11.0.0.2, timeout is 2 seconds:
?????
Success rate is 0 percent (0/5)
ASA# ping 11.0.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 11.0.0.1, timeout is 2 seconds:
?????
Success rate is 0 percent (0/5)
ASA#
Thanks
