03-03-2015 11:30 AM - edited 03-11-2019 10:35 PM
Hi,
how can apply route-map rules to an interface ?
i set up some rules but i cannot apply these rules any interface.
Thanks a lot.
03-03-2015 05:51 PM
Hi,
Are you looking for this?
hostname(config-route-map)# match interface if_name
http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/route_maps.html#wp1122131
Regards,
Kanwal
Note: Please mark answers if they are helpful.
03-04-2015 12:23 AM
Thank you Kanwal.
in a cisco router you can apply your route-map by using command ip policy map ... İ didnt find any command like this. İ set up some match and set conditions but i do not apply any interface.
can i use route-map to manipulate routing table İn asa 5585-x.?
sincerely
03-04-2015 07:26 AM
You use the "ip policy route-map ..." command when it is PBR but the ASA does not support PBR.
You can apply your route map under your routing protocol configuration when you redistribute from one routing protocol to another.
What is it you are trying to do ?
Jon
03-04-2015 07:26 AM
Thank you for all replies.
Unfortunately, i have to change next hop for specific source address. I guess this is not possible.
04-08-2015 01:15 AM
Hi,
A new feature added on ASA with 9.4 image. We can apply a route-map in physical interface by command
policy-route route-map NAME.
Thanks for all reply.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide