cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1064
Views
0
Helpful
5
Replies

ASA 5585-X Route-Map

aydinnmu1
Level 1
Level 1

Hi,

how can apply  route-map rules to an interface ?

i set up some rules but i cannot apply these rules any interface.

Thanks a lot.

5 Replies 5

Kanwaljeet Singh
Cisco Employee
Cisco Employee

Hi,

Are you looking for this?

hostname(config-route-map)# match interface if_name 

http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/route_maps.html#wp1122131

Regards,

Kanwal

Note: Please mark answers if they are helpful.

Thank you Kanwal.

in a cisco router you can apply your route-map by using command ip policy map ... İ didnt find any command like this. İ set up some match and set conditions but i do not apply any interface.

can i use route-map to manipulate routing table İn asa 5585-x.?

sincerely

You use the "ip policy route-map ..." command when it is PBR but the ASA does not support PBR.

You can apply your route map under your routing protocol configuration when you redistribute from one routing protocol to another.

What is it you are trying to do ?

Jon

Thank you for all replies.

Unfortunately, i have to  change next hop for specific source address. I guess this is not possible.

aydinnmu1
Level 1
Level 1

Hi,

A new feature added on ASA with 9.4 image. We can apply a route-map in physical interface by command

policy-route route-map NAME.

Thanks for all reply.

Review Cisco Networking for a $25 gift card