03-28-2017 04:55 PM - edited 03-12-2019 02:08 AM
Hi,
Setting up a pair of 5525X ASA firewall for failover. Connecting the ASA Failover link back to back with an ethernet cable works fine. When i connect failover ports with a switch in between with a dedicated vlan configured, Layer 1 will not even come up, the switchport is in down down state. Port is configured as an access port.
Any ideas?
03-28-2017 09:11 PM
It should work as that's a perfectly supported setup.
Can you share the "show run interface <relevant port>" and "show interface <relevant port>" output from the ASAs and the switch?
03-29-2017 10:31 AM
Thanks for responding Marvin, the configuration was good. turned out to be a combination of bad switchport and cable.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide