05-02-2012 01:26 PM - edited 03-11-2019 04:01 PM
Hello,
I've got a few syslog servers I need to send specific informational that consists of the following:
Source/Destination/Service (Firewall Logs)
I'm having some difficulty located the proper syslog messages found in this link: http://www.cisco.com/en/US/docs/security/asa/asa84/system/message/logmsgs.html
Which syslog messages should I configure to enable this requirement?
Any help would be greatly appreciated.
Regards,
Phillip
Solved! Go to Solution.
05-02-2012 01:32 PM
You would need to enable the logs at informational level or higher for it, you can refer to this doc for it:
https://supportforums.cisco.com/docs/DOC-18813
Also these logs shoudl be the one that you should be interested in 302013 and 302014:
http://www.cisco.com/en/US/docs/security/asa/asa84/system/message/logmsgs.html#wp6482625
Hope that helps,
Thanks,
Varun
05-02-2012 01:32 PM
You would need to enable the logs at informational level or higher for it, you can refer to this doc for it:
https://supportforums.cisco.com/docs/DOC-18813
Also these logs shoudl be the one that you should be interested in 302013 and 302014:
http://www.cisco.com/en/US/docs/security/asa/asa84/system/message/logmsgs.html#wp6482625
Hope that helps,
Thanks,
Varun
05-02-2012 02:01 PM
Thanks for the quick answer Varun! Much appreciated.
Regards,
Phillip
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: