cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1538
Views
0
Helpful
1
Replies
Beginner

ASA 8.4 ASDM 6.4 log viewer. Not able see names or filter by name - only IP

Experts,

I have a 5520 with ASA 8.4(1) and ASDM 6.4(1)

In the ASDM log viewer I can only see IP addresses and not names. Not sure if this is by design.

I have the "names" command configured but no ojects defined with the name x.x.x.x description

I figure this is something to do with the 'name' or 'names' command but these seem somewhat irrelevant with the new object definition style.

Is there a simple check box that I've missed somewhere?

TIA

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

ASA 8.4 ASDM 6.4 log viewer. Not able see names or filter by nam

Hi,

This is a known issue. It occurs due to the ASA migration from pre-8.3 to post 8.3 versions. Here is the relevant bug:

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCti38856

This would be helpful too:

https://supportforums.cisco.com/docs/DOC-12529

Hope this was useful.

Regards,

Anu

P.S. Please mark this question as answered if it has been resolved. Do rate helpful posts.

View solution in original post

1 REPLY 1
Highlighted
Cisco Employee

ASA 8.4 ASDM 6.4 log viewer. Not able see names or filter by nam

Hi,

This is a known issue. It occurs due to the ASA migration from pre-8.3 to post 8.3 versions. Here is the relevant bug:

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCti38856

This would be helpful too:

https://supportforums.cisco.com/docs/DOC-12529

Hope this was useful.

Regards,

Anu

P.S. Please mark this question as answered if it has been resolved. Do rate helpful posts.

View solution in original post