cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1611
Views
0
Helpful
1
Replies

ASA 8.4 ASDM 6.4 log viewer. Not able see names or filter by name - only IP

renoufi
Beginner
Beginner

Experts,

I have a 5520 with ASA 8.4(1) and ASDM 6.4(1)

In the ASDM log viewer I can only see IP addresses and not names. Not sure if this is by design.

I have the "names" command configured but no ojects defined with the name x.x.x.x description

I figure this is something to do with the 'name' or 'names' command but these seem somewhat irrelevant with the new object definition style.

Is there a simple check box that I've missed somewhere?

TIA

1 Accepted Solution

Accepted Solutions

Anu M Chacko
Cisco Employee
Cisco Employee

Hi,

This is a known issue. It occurs due to the ASA migration from pre-8.3 to post 8.3 versions. Here is the relevant bug:

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCti38856

This would be helpful too:

https://supportforums.cisco.com/docs/DOC-12529

Hope this was useful.

Regards,

Anu

P.S. Please mark this question as answered if it has been resolved. Do rate helpful posts.

View solution in original post

1 Reply 1

Anu M Chacko
Cisco Employee
Cisco Employee

Hi,

This is a known issue. It occurs due to the ASA migration from pre-8.3 to post 8.3 versions. Here is the relevant bug:

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCti38856

This would be helpful too:

https://supportforums.cisco.com/docs/DOC-12529

Hope this was useful.

Regards,

Anu

P.S. Please mark this question as answered if it has been resolved. Do rate helpful posts.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers