cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

666
Views
0
Helpful
1
Replies
Highlighted
Beginner

ASA Active/Standby Connection...

We configuring ASA 8.4.2 in Active/Standby failover mode with two cables. What would be the best design configuring etherchannel on ASAs or have one active and one standby redundant cable ?

1 REPLY 1
Highlighted
Hall of Fame Guru

I do not believe that it is possible to configure etherchannel for failover on the ASA. If you have two cables available then the recommendation from Cisco is that you use one cable as the failover interface (used to check on the health of the peer and to perform failover activity) and use the other cable to pass state information between the ASAs.

HTH

Rick

HTH

Rick
Content for Community-Ad