cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

751
Views
0
Helpful
0
Replies
George-Sl
Beginner

ASA Cluster Solution without FMC

ProductsFunctionMinimum VersionRequired?

Firepower 4100 or 9300

Hardware platform to run the ASA

FXOS 1.1.2

Required

Firepower Chassis Manager

FXOS GUI device manager

Firepower Chassis Manager 1.1.2

Optional; you can alternatively use the CLI

ASA

Firewall application

ASA 9.4(1.152)

Required

ASDM

ASA GUI device manager

ASDM 7.4(3)

Optional; you can alternatively use the CLI

 

According to this table FMC is not required for ASA Cluster Solution, how can I set the CCL MTU 100 bytes higher than the DATA MTU?

image.png

and editing the mac address for the outside interface, if you can guide me how I should do it from the FX-OS cli?

 

I think this was not part of the FX-OS at all,

the way they stated these things on cisco https://www.cisco.com/c/en/us/td/docs/security/firepower/fxos/clustering/asa-cluster-solution.html

it's like you have to either do it on FMC or you can't!

It says if you're deploying FTD you need to open the FMC manager, and if you're deploying ASA you need to go here Configuration > Device Setup > Interface Settings > Interfaces

it hasn't even mentioned you need to open ASDM

I was lost in FCM to find this menu, and finally I realized oh it's ASDM, I don't even need ASDM for this, you just need to change it on ASA CLI

MTU Cluster 9100

and

under the spanned outside/inside portchannel

mac-address aaaa.aaaa.aabb

 

could you correct me if I am wrong?

0 REPLIES 0
Content for Community-Ad