Hi guys
I have 2 ASA firewalls active/standby version 9.8(2)
by ASDM I change the security level of the interface from 100 to 0
then I found this message in below photo
I didn`t read the message I want to finish this task quickly so I press on "force send"
after that, the failover is down, any configure do at the active don`t apply at the standby one
and at sh run, i find this
"
failover
failover lan unit primary
failover lan interface LANFAIL Port-channel1
failover key *****
failover link LANFAIL Port-channel1
failover interface ip LANFAIL 10.10.1.1 255.255.255.0 standby 10.10.1.2
"
at bot active and standby
So, this means that failover is gone and I must configure it from the beginning
and what the required configuration for that
and if make this, I will need to reset the ASA to activate this configuration?
Please any response ASAP
Thanks