ā12-12-2018 09:27 AM - edited ā03-12-2019 07:10 AM
Hi
I am in middle of an implementation of FTD and FMC
I am facing an issue with the interfaces in FTD. We have 2x2140 devices which is added to FMC with the management interface. Connected a 10G port to core switch and it came up but rest all ports are not coming up. Can somebody help me in this case.
ā12-12-2018 09:41 AM
Hi,
Have you configured the interfaces of the device in the FMC and deployed the policy? The interfaces will only come up once you've done that.
HTH
ā12-12-2018 09:48 AM
Hi Thanks for the response.
I have enabled the interfaces on both firewalls from FMC but no policies are configured yet. Unless configuring any policy, there is one interface which came up.
One thing to be mentioned is that, the one interface which is up now, is connected before adding the devices to FMC. After adding to FMC there was license sync error seen and contacted cisco licensing team to resolve it.
ā12-12-2018 09:48 AM
Hi Thanks for the response.
I have enabled the interfaces on both firewalls from FMC but no policies are configured yet. Unless configuring any policy, there is one interface which came up.
One thing to be mentioned is that, the one interface which is up now, is connected before adding the devices to FMC. After adding to FMC there was license sync error seen and contacted cisco licensing team to resolve it.
ā12-12-2018 09:56 AM
ā12-12-2018 09:44 AM
ā12-12-2018 09:49 AM
ā12-12-2018 09:51 AM - edited ā12-12-2018 09:53 AM
To which device is the FTD is connecting. Is your FTD in HA...???
I mean is it in VSS or VPC or Etherchanel..?
ā12-12-2018 09:57 AM
ā12-12-2018 10:02 AM - edited ā12-12-2018 10:45 PM
So both are individual firewalls, Can you check the speed of interfaces in both the side.
Can you share a screen shot from FMC for interface configuration and the other side switch interface configurations.
ā12-12-2018 10:09 AM
ā12-12-2018 10:17 AM
ā12-12-2018 10:22 AM
ā12-27-2019 08:24 AM
Hi All,
It is old forum but i like to give my answer as someone will get benefited.
once you have enabled the interface, you must give "commit-buffer" command which will bring up your interfaces.
ā08-19-2024 01:14 AM
commit-buffer where
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide