cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3381
Views
0
Helpful
16
Replies

ASA/FTD Firepower Update Procedures

nevin.maurice1
Beginner
Beginner

Hello

 

We have an urgent situation to try and get our Cisco Firewalls/Firepower devices up to the latest 6.2.2.x version.

 

We currently have the following environment with devices running in HA (Active-Standby) so 2 devices of each below.

 

Firepower Management Center = 6.2.0.3

 

2 x FTD 4110 > Firepower = 6.2.0.2 , FXOS = 2.1(1.72)(1)

 

2 x ASA5516X-SFR > ASA = 9.5.3, Firepower = 6.1.0.3

 

2 x ASA5516X with FTD > Firepower = 6.2.0.2

 

 

What are the upgrade procedures (and version path) to get all these devices up to version 6.2.2.x

 Cisco's Compatibility Matrix is not the most clear.

Thanks

16 Replies 16

Thanks Marvin,  I just wanted to make sure it wasn't  . . . . . 

 

Run Pre-install for FMC from 5.4.1.8 to 6.0

Sourcefire_3D_DefenseCenter_S3_6.0.0_Pre-install-5.4.1.999-21.sh

Run Pre-install to upgrade sensor to 6.0

 

Cisco_Network_Sensor_6.0.0_Pre-install-5.4.0.999-2.

Upgrade FMC to 6.0

Sourcefire_3D_Defense_Center_S3_Upgrade-6.0.0-1010.sh

Upgrade Network Sensor to 6.0.0-1005

Cisco_Network_Sensor_Upgrade-6.0.0-1005.sh

 

 

I really appreciate your help.

DO NOT attempt this upgrade.  Follow Marvin's advice and re-image the modules/sensors ONLY. 

We use the FMC virtual appliance and it saved days of work taking this shortcut. We ran into way too many issues trying to upgrade the sensors.

 

Take VM snapshot before upgrading 

Disconnect the SFR modules in the FMC

Upgrade FMC only all the way to 6.2.2 following the upgrade migration path.

Re-image modules directly to 6.2.2

Add modules in FMC.

Deploy.

 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: