08-02-2019 08:42 AM - edited 02-21-2020 09:21 AM
Hi All,
Can someone explain how the ASA uses the standby IP in a Active/Standby config. I have always configured the devices like this as per cisco design. Tried to look into this further but unable to find a definitive answer. When the PRIMARY fw fails, the Secondary uses the IP & MAC of the of the PRI - so how does it use the standby IP configured on the interface?
Regards, mk
08-02-2019 11:49 AM
08-02-2019 11:52 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide