08-02-2019 08:42 AM - edited 02-21-2020 09:21 AM
Hi All,
Can someone explain how the ASA uses the standby IP in a Active/Standby config. I have always configured the devices like this as per cisco design. Tried to look into this further but unable to find a definitive answer. When the PRIMARY fw fails, the Secondary uses the IP & MAC of the of the PRI - so how does it use the standby IP configured on the interface?
Regards, mk
08-02-2019 11:49 AM
08-02-2019 11:52 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: