cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
602
Views
0
Helpful
1
Replies

ASA Redundant Interface

Ahmad Khalifa
Level 1
Level 1

on the ASA5520 i have configured 2 interface as Redundant Interface the behavior of the these interfaces one will be active and the other one remian Stand by till the active one fail or forced to change my Question is there is any way to make those Redundant Interface in Active Active state because each on will connect to different Switch 

1 Accepted Solution

Accepted Solutions

Jon Marshall
Hall of Fame
Hall of Fame

No there isn't because by definition one is redundant.

If they were both separate interfaces and they were both active then they would need to have different IPs ie. be in different subnets which is not what you want.

The alternative is if the switches you are connecting to are a stack or 4500/6500 using VSS or Nexus with vPC then you could create an etherchannel with both ports and then they would both be active.

Jon

View solution in original post

1 Reply 1

Jon Marshall
Hall of Fame
Hall of Fame

No there isn't because by definition one is redundant.

If they were both separate interfaces and they were both active then they would need to have different IPs ie. be in different subnets which is not what you want.

The alternative is if the switches you are connecting to are a stack or 4500/6500 using VSS or Nexus with vPC then you could create an etherchannel with both ports and then they would both be active.

Jon

Review Cisco Networking for a $25 gift card