06-18-2013 08:45 AM - edited 03-11-2019 06:59 PM
We just purchased two 6513s that we are going to arrange into a VSS with two supervisor 2Ts.
Each chassis will also have the new ASA services module.
I can't seem to find decent documentation on how to set up active standby failover between the ASA modules when they are in a VSS environment. Traditionally, I have set up the FWSMs between two switches using the failover link, etc. This is new.
Can anyone point me in the right direction, or give me a simple conifg? I want to make sure I understand how to do this.
thanks
Solved! Go to Solution.
06-19-2013 06:12 AM
AFAIK you do it the same as with the FWSM - using a dedicated logical VLAN interface for the failover (and optionally another for the state) link.
06-19-2013 06:12 AM
AFAIK you do it the same as with the FWSM - using a dedicated logical VLAN interface for the failover (and optionally another for the state) link.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: