ASA SFR module reimage 6.1

[ali.rodriguez]

Reimage to 6.1 version in ASA sfr module in 5508-X.

There is a pre-install package that i have to use in this installation but i dont know what have I to do with that file.

Someone know the command to run this package or when I have to run it?

Regards

[Marvin Rhoads]

We use an img file and pkg file. Complete instructions on how the process works can be found here:

https://community.cisco.com/t5/security-blogs/reimage-firepower-module-in-cisco-5500-x-firewall-models/ba-p/3760395

[ali.rodriguez]

So, the pre-install package is not needed?

[Kasun Bandara · Accepted solution]

Hi,

pre installation packages are normally using between upgrades. if you need to do a clean installation, use below guide.

https://community.cisco.com/t5/security-blogs/reimage-firepower-module-in-cisco-5500-x-firewall-models/ba-p/3760395

mark this as answer or upvote if this solved your concern

KB

[Marvin Rhoads · Accepted solution]

@ali.rodriguez Correct -  a pre-install package is not needed when reimaging.