I updated my ASA 5510 SSM modules this morning to 7.0.(4)E4. Ever since then both my primary and failover unit has been showing at what I am guessing is 100% processor utilization.
Primary:
Memory Usage
usedBytes = 663646208
freeBytes = 368848896
totalBytes = 1032495104
Summertime Statistics
start = 03:00:00 UTC Sun Mar 13 2011
end = 01:00:00 GMT-06:00 Sun Nov 06 2011
CPU Statistics
Usage over last 5 seconds = 100
Usage over last minute = 99
Usage over last 5 minutes = 99
Memory Statistics
Memory usage (bytes) = 663646208
Memory free (bytes) = 368848896
Auto Update Statistics
lastDirectoryReadAttempt = N/A
lastDownloadAttempt = N/A
lastInstallAttempt = N/A
nextAttempt = 16:25:24 UTC Sat Apr 30 2011
Failover:
Memory Usage
usedBytes = 665214976
freeBytes = 367280128
totalBytes = 1032495104
Summertime Statistics
start = 02:00:00 UTC Sun Mar 13 2011
end = 02:00:00 UTC Sun Nov 06 2011
CPU Statistics
Usage over last 5 seconds = 100
Usage over last minute = 100
Usage over last 5 minutes = 100
Memory Statistics
Memory usage (bytes) = 665214976
Memory free (bytes) = 367280128
Auto Update Statistics
lastDirectoryReadAttempt = 20:26:48 UTC Sat Apr 30 2011
= Read directory: https://198.133.219.25//cgi-bin/front.x/ida/locator/locator.pl
= Success: No installable auto update package found on server
lastDownloadAttempt = N/A
lastInstallAttempt = N/A
nextAttempt = 21:26:43 UTC Sat Apr 30 2011
Anyone have any suggestions on what I should do? I figure since my failover doesnt have ANY traffic going through it that it being pegged at 100% means something is seriously wrong.
