cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

152
Views
0
Helpful
3
Replies
Highlighted

ASA Standby Firewall Requirements

Hi,

I have ASA 5510 firewall with security Plus bundle license is running in our production environment and i am now buying another box for Standby Firewall so as per my understanding the standby should be same as the active one firewall.

Below are the specs that running in our existing environment

1. ASA 5510 Firewall (Security Plus Bundle License, 1 GB RAM, 256 MB Flash)

And buying same replica of above with security bundle license, 1 GB RAM, 256 MB Flash.

My question is, is there anything else that i am missing for standby firewall?

 

Regards,

Saeed

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

ASA failover partners must have the same number?

By this i am assuming you are refering to the same number of interfaces.  these interfaces also need to be of the same type.  so you can not have one ASA with 4 Gig interfaces and the other with 2 Gig interfaces.  Or you can but you will not be able to use failover for 2 of the interfaces on the ASA with 4 Gig interfaces.  Likewise, if both ASAs have 4 interfaces but one ASA has 4 Gig interfaces while the other has 4 Fastethernet interfaces, then this would not be supported.

--

Please remember to select a correct answer and rate helpful posts

--
Please remember to select a correct answer and rate helpful posts

View solution in original post

3 REPLIES 3
Highlighted
Participant

Highlighted

Hi Aref,

Thanks for the reply.

Can you please specify this sentence in more details.

****ASA failover partners must have the same number?

 

Regards,

Saeed

Highlighted

ASA failover partners must have the same number?

By this i am assuming you are refering to the same number of interfaces.  these interfaces also need to be of the same type.  so you can not have one ASA with 4 Gig interfaces and the other with 2 Gig interfaces.  Or you can but you will not be able to use failover for 2 of the interfaces on the ASA with 4 Gig interfaces.  Likewise, if both ASAs have 4 interfaces but one ASA has 4 Gig interfaces while the other has 4 Fastethernet interfaces, then this would not be supported.

--

Please remember to select a correct answer and rate helpful posts

--
Please remember to select a correct answer and rate helpful posts

View solution in original post

Content for Community-Ad