cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1133
Views
0
Helpful
0
Replies

ASA threat-detection drop rate Messages

Elie Bassil
Beginner
Beginner

Hi,

I have on my ASA threat-detection configured. I see the below in my logs:

[ Scanning] drop rate-1 exceeded. Current burst rate is 10 per second, max configured rate is 12; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 4557

[ Scanning] drop rate-2 exceeded. Current burst rate is 8 per second, max configured rate is 10; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 27755

[ Scanning] drop rate-1 exceeded. Current burst rate is 10 per second,max configured rate is 12; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 4702

[ Scanning] drop rate-2 exceeded. Current burst rate is 8 per second,max configured rate is 10; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 27835

Previously, the configured rates were lower then the rates that are occuring, so I increased the configured rates to 12/10 and 10/10 but still getting the above messages. Should I adjust the rate-interval as well? And how?

thanks,

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: