Showing results for 
Search instead for 
Did you mean: 

ASA upgrade failure

Level 1
Level 1

Hello team, 


plz your support 

about the below ... the asa without any firmware now .. how can I solve this and the memory i think its filled.Capture.PNG

5 Replies 5

Philip D'Ath
VIP Alumni
VIP Alumni

Delete old files off the flash you don't need (such as the old firmware).


dir flash:

delete flash:xxx

there is no firmware :(

Find other files you can delete.  Perhaps old anyconnect packages, etc.

Is that the legacy 5505? With the default flash, there is only space for one firmware, asdm and two anyconnect images. If that's the case you have to delete one of the actual used files and then load the new one. You can also delete the running image and load a new one. But you should make sure that no one cuts the power while upgrading ...

i entered to rommon and makes may pc as tftp and working with the asa fine . but when i make copy tftp disk ... the ERROR message shown that there is no space .


you can see this




Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card