cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
577
Views
0
Helpful
3
Replies

ASA5510 Memory Upgrade and Software Upgrade with HA

Mady
Level 4
Level 4

Hi Team,

May I seek your help on subject-above. We have HA ASA5510 with software version 8.0(3) with 256MB memory. We will upgrade the software to 8.2(5.59). Does it have an upgrade-path [8.0(3) > 8.2(5.59)]?Also, Is it possible to upgrade the memory module without downtime? Can you give me a reference on how can I do the memory upgrade? Thank you very much.

Regards,

Mady

1 Accepted Solution

Accepted Solutions

Shivapramod M
Level 1
Level 1

Hi Mady,

You can upgrade the device from 8.0.3 to 8.2.5.559 directly.

You need downtime for the memroy upgrade. Please refer "Replacing Memory in the Adaptive Security Appliance" section in below link

http://www.cisco.com/c/en/us/td/docs/security/asa/hw/maintenance/guide/asa_hw/procs.html#pgfId-1078210

Thanks,
Shivapramod M
Please remember to select a correct answer and rate helpful posts

View solution in original post

3 Replies 3

Shivapramod M
Level 1
Level 1

Hi Mady,

You can upgrade the device from 8.0.3 to 8.2.5.559 directly.

You need downtime for the memroy upgrade. Please refer "Replacing Memory in the Adaptive Security Appliance" section in below link

http://www.cisco.com/c/en/us/td/docs/security/asa/hw/maintenance/guide/asa_hw/procs.html#pgfId-1078210

Thanks,
Shivapramod M
Please remember to select a correct answer and rate helpful posts

Hi Shivapramod,

Thank you for your answer. 

Hi Shivapramod,

For clarification only, If I will upgrade first the memory of secondary-stand-by. The primary active will continue network traffic. So it is not possible to connect again the secondary after the upgrade of memory then force the secondary to be active?

Regards,

Mady

Review Cisco Networking for a $25 gift card